Amfab

"An issue where it was not possible to return audio from an Aux higher than Aux 8 is resolved" Im DLing now, I hope this means that the busses above 8 are fully functional update: it seems to work!

I would love if there was some way of doing this but I cant figure it out either. Essentially what you wanna do is pan between two busses (or two outputs) Here is my work around: On a channel strip make two sends and assign them two separate busses (or outputs)–one will be your left monitor mix and the other will be the right. I use a directional knob and map it to control the volume of each send, but I reverse the volume parameters so when the knob is all the way right one send is at full volume and the other is fully attenuated and when it is all the way left it is the reverse. You need to use the parameter curves to make it non linear. the curves have to be opposite to get the cross fade smooth. If this doesnt make sense let me know and Ill post pictures later Because the knob is a volume knob the little lights dont light up like a knob that is assigned to be an actual pan, so I make the color of the knob black* so it doesn't appear so much like a volume knob. This is why I use the directional knob so it is easy to see where I am panned. *to make the color more invisible: if you choose black and then choose "custom" you can you use the sliders to set the brightness to 12% and its almost impossible to tell.

Thank you for the help, but there seems to be a bug because when I group that many things the graphics freak out, move and resize. Very dissapointing, it would seem like a simple preference to add– the ability to have different setups within the same concert. Maybe Concerts>Sets>patches&venues or something so you can configure a pedal board for one set up and a mixer for another. I guess I will just have to have multiple files open and switch between them that way ....kinda weak

I am trying to create a concert with two completely different mixer layouts, (by different I mean different amounts of faders, routing, and postions on screen.) Here is what I am doing I created a new MS document then made a mixer and saved it, ill call it Mixer 1. I created another MS document, made a different mixer and saved it as Mixer 2. In the Mixer 2 document I went to the patch list, selected the concert and exported by choosing save as set. I would like to import the Mixer 2 into the Mixer 1 concert so I can switch between the two mixers. But when I import Mixer 2 to the Mixer 1 concert by going to the patch list and chosing load patch/set the layout of Mixer 1 gets applied to the imported Mixer 2. Am I missing something completely obvious here? I want the new layout to import. I searched the manual, help, and these forums and cant figure this out. Any help in getting the desired result of two different mixer layouts would be greatly appreciated TIA