beefheart1

No, I've only ever used Pro 9 and never had earlier versions of Logic.

Still not working on original project however!?!

Well, I've opened a seperate project and the bus / aux is working as normal with no problems.

Hi. First up can I say I'm still using Pro 9 but was hoping someone here could help me with this problem? All of a sudden I've run into problems with my aux / bus sends three quarters of the way through a project. If I put a bus on a track no corresponding aux channel strip is appearing in the aux strip section. What's more, I'm occasionally getting signal from instruments being sent to other aux channels within aux channels not being routed to by that instrument! Finally, if I open a new bus send on a particular channel and send it to an already existing aux, no signal is coming through!! Any fix' would be greatly appreciated.

Wonder if anyone can help? I'm a beginner to logic. I'm running pro 9 on a Mac OSX Lion and have installed a Focusrite Pro 24 DSP (with VRM) as my interface. Everything was working fine with Logic defaulting to the Focusrite and, accordingly, allowing me to monitor my sound as I record via a pair of Rokit 5 speakers (which are plugged in to the focusrite); however, I have now installed a Korg PadKontrol midi controller to allow me to play my own beats / drum patterns and since this no sound is coming out via my Rokit monitors and a sign pops up when I open Logic informing me that monitoring via the previous selected route (I.e: via the focusrite and my Rokits) is no longer available. I have tried to remedy the situation but, unfortunately, have not managed this. Any suggestions? (If so, please explain it to me as if I was a child!!!).