nataraj Posted April 19, 2014 Share Posted April 19, 2014 Hello. Im thinking of to buy an Behringer Powerplay P16I Module and a P16M Personal Mixer so i can send separate audio to the recording room from the ADAT on my SSL Alpha Link soundcard. I plan to send the audio in Logic with SENDS set on Pre fader to an AUX, and then take the Aux channel and send it out via ADAT to the Powerplay. My question is if its possible for me to put a track in SOLO and the audio im sending to the recording room is not affected by my solo listening.. That would be handy so i can listening to the instrument / vocal that is under recording in solo in the control room, and the artist is not affected by that, and can set their own volume in the recording room.. Grateful for help with this rather difficult question. Best regards / Thomas Quote Link to comment Share on other sites More sharing options...
Atlas007 Posted April 21, 2014 Share Posted April 21, 2014 Make a distinct stem to bounce. Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted April 21, 2014 Share Posted April 21, 2014 My question is if its possible for me to put a track in SOLO and the audio im sending to the recording room is not affected by my solo listening. I'm afraid that's not possible. Quote Link to comment Share on other sites More sharing options...
nataraj Posted April 21, 2014 Author Share Posted April 21, 2014 To bad. Would be a good thing to put in next version of Logic. And to do advanced internal routing in Logic is not possibe? Thanx for the reply.. =) Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted April 21, 2014 Share Posted April 21, 2014 I'm not sure what you mean by advanced internal routing, but you can only route audio using channel strips and busses. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.