ES2 Complete Reset

[Fries]

Hello,

I'm requesting a "Complete Reset" preset for the ES2.

All parameters set to zero, oscillators off, X Y panner to center, no FX processing, No routing done, Filter set to pass all frequencies.

I could do this myself, but I would forget something. If no one delivers I will probably just do it myself .

I pray for someone to deliver though, because I do not want to take the time.

In all honesty the most awesome thing would be if this preset was in ES2 and I just haven't found it.

I know Steve Horelick has one of these presets *ahem*....

[Fries]

Delivered...


If you guys notice something still up let me know about it. In this mode pretty much your browsing wave forms. Thats it. A good place to start from scratch, no?

[Mehdi]

Haven't tried your preset, but when i want an init preset, I just open the Saw Init preset on the tutorials section (no sure it is the correct name).
It has a saw wave, one filter fully open no pan etc ...

[David]

I spotted (and fixed) quite a few things, especially in the router and modulation sections, but also one oscillator was slightly out of tune, couple of things here and there, also I reset the envelopes to their default value (Option-clicking the sliders), which you may or may not like.

[Archaic504]

once i download the complete reset patch how do i find it in logic/es2?

new to this. thanks for all the help in advance.

[lostinthesound]

once i download the complete reset patch how do i find it in logic/es2?

new to this. thanks for all the help in advance.

Read the first post HOW TO use the setting files in this forum

[Pirated]

Very nice thread, thanks

[Jasontuck]

I spotted (and fixed) quite a few things, especially in the router and modulation sections, but also one oscillator was slightly out of tune, couple of things here and there, also I reset the envelopes to their default value (Option-clicking the sliders), which you may or may not like.

This is just what I needed, thanks a lot!

Jason

[David]

You're welcome Jason!

[Clarinetdude]

Thanks David for this!
Very useful and something which I have been looking for in the ES2 synth presets but couldn't find....

[NiCO95]

If you go to the top of ES2 there's the presets tab... (for those that don't know), click on it and go down to tutorial settings... there should be a setting called Analog Saw Init (This means you are setting the plug-in to a single saw wave setting - in other words initializing the synthesizer to a saw wave), however, this is the nearest to resetting the ES2 you can get by a preset that is already in logic... but this is actually not initializing it, this is resetting it to their suggested initialized setting.

I will stop rambling on about what i wanted to say about logic's "bad init preset" and tell you how to COMPLETELY RESET THE ES2...
Click the Analog Saw Init preset, then hold alt on the keyboard and click EACH AND EVERY SINGLE BUTTON, KNOB, AND FADER on the ES2. Each one you click they might twitch a little because that's were the initial setting should be. Once everything is clicked you are best saving the preset so you don't have to do this in the future. I titled my preset as BLANK, haha hope this helped and was informal.

NiCO, 17 year old producer from Carlisle, UK.