Klotzi Posted February 2, 2007 Share Posted February 2, 2007 Hello, does anybody made the experience with a Motu 828mk2 (firewire) and Logic, that every time you open Logic a extremly high frequency sound is buzzing out of...hm I don't know (I think from the Mac), but definitly not the speakers. It's not very loud so if you play music from Logic you will not recognize it. If I put my ear to the Motu in my rack I hear that sound also even if Logic is not open but much more quiet. Any ideas what this could be? Quote Link to comment Share on other sites More sharing options...
tovinho Posted February 2, 2007 Share Posted February 2, 2007 Hi! I use a 828 usb2 with a macbook, and it´s just fine. I really never had the problem you wrote about. Quote Link to comment Share on other sites More sharing options...
dkgross Posted February 2, 2007 Share Posted February 2, 2007 yup..my 828MKII has been without issues. Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted February 2, 2007 Share Posted February 2, 2007 Try a hardware reset of the MOTU: Follow these steps to restore the 828mkII to Factory Default Settings. Disconnect the firewire cable from the 828mkII Press the Setup knob Turn the Setup knob all the way to the right Press the Select knob Press the Value knob Power off the interface and plug the firewire cable back in Power the interface back on Quote Link to comment Share on other sites More sharing options...
hesterthepirate Posted July 28, 2010 Share Posted July 28, 2010 Hey guys when I listen to projects in logic through my motu the sounds seems to be a bit distorted and not clean. But when I listen to the same project in logic but with my speakers now coming through the head phone Jack on my mac and not my FireWire cable and through the motu, the sound is clean. Any ideas on what I'm doing wrong? Thanks Hester Quote Link to comment Share on other sites More sharing options...
triplets Posted July 28, 2010 Share Posted July 28, 2010 Do you connect the motu to external speakers? Quote Link to comment Share on other sites More sharing options...
ted_manzie Posted April 10, 2012 Share Posted April 10, 2012 Try a hardware reset of the MOTU: Follow these steps to restore the 828mkII to Factory Default Settings. Disconnect the firewire cable from the 828mkII Press the Setup knob Turn the Setup knob all the way to the right Press the Select knob Press the Value knob Power off the interface and plug the firewire cable back in Power the interface back on 2 years later but I just found this tip as my 828 had suddenly stopped working with logic. I was at the end of my tether - deadline tomorrow and no sound! Sorted!! Thanks David Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted April 10, 2012 Share Posted April 10, 2012 Sorted!!Thanks David Good to hear! A long time ago I was in a bind too and someone shared that tip with me, which saved my buttocks. Now I'm just spreading the word. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.