Hello
I´m kind of new with Logic
I need advice with the following matter
I`m using version 10.6.2
I have two motu interfaces, a new 24 Ai and an old Ultralite mk1
OSX Catalina 10.15.7
I can use both interfaces to work as one (aggregated device)
or using the ultralite as output device and the 24Ai as input device
now,, I need a second output from logic to send an audio sync signal to my Acme SND master clock, as I use logic to record 24 channels from my Midas 240 direct outputs
in order to being able to do this, besides setting up the 24 ins in logic with the 24ai interface,I need to open an instrument track so I can open on it a plug in that send an audio signal to the motu ultralite, this audio signal then is routed to one of the 8 outputs of the ultralite,,say.. output 8
the ultralite also works as master output, as you know the motu 24Ai have only inputs
this audio signal then is connected to a audio input on my master clock, then the master clock convert use this audio sample to sync all my gear, the master clock then can send midi, analog clock and din-sync to all my stuff
so far the best way the whole system runs is when I use both interfaces independently,, but it is also fine to use both as aggregated device
ok now the problem I have is: no matter which of the 2 methods I use, as aggregated device or each by it´s own ( ultralite as master ouput plus the audio signal to the master clock to the Acme SND, then the 24Ai as the audio input device) I cant figure out how to have two different outputs in logic, I want this because I need to keep the ultralite audio signal on it´s number 8 output totally independent from the master output, so it do not get mixed into the master
what is happening is this: if I want to use software monitor with the audio signal running on it´s out track, I can have the master output metter on the mixer, I need to delete the track, then mix the stuff,, then create again the instrument track, add the plug in and then when I record I wont have the master output meter on the signal,, and I need it to keep the master mix from being too hot
how can I have two outputs on logic? one for listen software monitor that is being recorded to the 24ai, and a second one that can send to the ultralite so I can listen the master output from logic, but also need to send this independent audio signal to output 8 on the ultralite? or I need three?
as I said, I`m new to logic, sorry if the question is to silly but I have been triyng the whole week,,and I need to deliver stuff
thanks for your attention, andy advise is greatly appreciated