timbeats

Thanks !

Ok so I got the faders working the way I want with ease after reading that thread which , now that I mention, am surprised I didn't find in the first place. Anyway I am almost there. What I am trying to do is setup a template that will speed up my work flow(like everybody else does I'm sure.) So, I have 26 tracks, 24 of which will contain audio and midi data. The axiom has buttons below the faders which I would like to set to move between two sets of 8 channels. My guess is that I would have to set each button as a key command to hide or switch between groups of channels. Am I right? If so how would I go about this? Thanks again

Thanks so much for the quick response. Man that was fast! Ok so I got the faders working the way I want with ease after reading that thread which , now that I mention, am surprised I didn't find in the first place. Anyway I am almost there. What I am trying to do is setup a template that will speed up my work flow(like everybody else does I'm sure.) So, I have 26 tracks, 24 of which will contain audio and midi data. The axiom has buttons below the faders which I would like to set to move between two sets of 8 channels. My guess is that I would have to set each button as a key command to hide or switch between groups of channels. Am I right? If so how would I go about this? Thanks again

Thanks so much in advance. I am going to try this now.

I have been searching all over the internet and the forum trying to figure this out so up front I do apologize if this has already been explained. I have an axiom as my main controller and have set up the transport buttons. What I want to know is if there is a way with one of my settings I can use the faders to adjust the volume of individual tracks and, as well, use the buttons below the faders to switch between different groups on the mixer. Is this possible? I am new to logic so I did start to mess around in the environment window but I just got nervous about messing things up too much. Please help! Thanks.