mldkgtr

Hey hey folks, I'm doing some recording using an Axe Fx II as the (input) audio interface into Logic Pro X. I also have an Apogee duet which for this purpose, I'm using as the output. I've recorded dry guitars and I'd like to re-amp them. I did this so I could get the playing part done, and work on building the right tone for as long as I need. The Axe FX is fantastic! It'll play the dry recording back via USB and allow you to re-record that same signal with new settings all within itself. The only problem is that it affects every track in the project, not just the guitar or selected track. As a result, I hear drums, bass additional guitars etc. all going through Mesa Boogie stack etc. In order to hear only the guitar, you have to either solo, or mute the other instruments which makes it pointless as you have no reference point of what the tone you're building sounds like with all the other instruments. I'm hoping to be able to synch a bounce of the other instruments and play it back in synch via another daw like Reaper or Garage Band so it plays independently of logic. This way, I can keep working in Logic and dial the tones, without affecting the rest of the tracks There are several ways to do this using additional analog gear, but I'd rather keep it all within the computer & Axe Fx & Apogee. Any suggestions, would be greatly appreciated. Best, MK

I read the rules right after posting the question, thnx!

David, I just ordered your book, but I have a question in the mean time. I'm looking to synch the playback between Logic & Reaper to do some re-amping via the Axe Fx. Unfortunately, the axe fx affects all audio in the daw it's in, so I'm hoping to play a bounce of drums/bass and have that play in synch through another daw like Reaper, or even garage band so the two can play independently. Any advice would be greatly appreciated. Thnx in advance!!!