Frans

Well i'll be damned.... i have been clicking that button like a maniac for 2 day's never thought of holding it down.... thankyouthankyouthankyou Yes it is the output device and if i dropdown that output section i see options to select channel outputs so i'll try that tonight and let you know but i assume this will do the trick. Again thanks a whole bunch

Hi Volovicg, thank you for your reply, where do i have that option on the channel strip? All i see is that its output is set to stereo but i cannot change that somehow, can't click on it only the box below it where i can select group or bus options. My system out at the moment is channel 15/16 and that works fine as i already changed that in the Audio/midi configuration but i can't change the output on the channel strip so individual channels don't want to come back to the mixer, just the stereo/system out. I can't for the life of me figure out what i am doing wrong, i have used Logic many times before with my Helixboard 18 but that was only used as a interface so it wasn't important back then, stereo out was enough but i now want to use my initial recording played back as a soundcheck option so i can record a second run with al the eq and effects i wanted.

Hi, i hope someone here can fill me in on how to route the individual recorded tracks from logic to my Presonus 16.0.2 so i can mix those tracks on the board. Everything is as it should be according to the presonus people audio/midi setting wise but i get no individual playback, only stereo but i cannot change this setting or at least not in the same virtual mixer in Logic where i also select the inputs per channel. Hope someone can help! Thans, Frans