VEGASYNTH

Since the update the little green speaker (audition) button will no longer stay green allowing the audio samples to play as you scroll in the browsers section. I must now click each sample individually, have been searching high and low for a solution and zero luck!

drum browsing sucks so bad in logic

Not sure how to better explain this but no ADSR or mono, legato, poly adjustments will correct the issue.

It always pops no matter what, that was just an example of it at its worse.

Ok try this, open ES2, select preset "sine bass".... in envelope 3 turn the release all the way down and hit some keys and tell me if it pops after each note finishes.

And thank you for your response.

It is mainly in ES2 when I am building sub bass, every time I strike a key to cut off the previous note an begin another I get a pop in between, when I mentioned ASDR I was referring to the attack adjustment but it is obviously a software issue because that makes no difference. I can have the attack way up where the synth is silent for a second after striking a key and I still get that nasty pop. I need mono enabled but I apologize, it happens in poly and legato as well, also happens in sculpture with really any sound I make. I often spend hours modifying and damaging my pieces trying to eliminate these pops hands on.

Since update I can no longer scroll through drum samples in the browser and hear them play as I scroll!!!! Pisses me right off lol. Got to click each one individually.

Hello! I have been trying to solve this issue for some time now and here I am finally begging for help lol! When I use certain synthesizers in Logic Pro X I get a popping/clip noise in between MIDI notes only in mono when the new note cuts off the old one.... The only way to correct this has been to bounce and fade (pain in ass). I have tried many times to correct buffer rate and also ASDR adjustments with zero luck.

I cant seem to generate a "to instruments" in the arp click and port

No luck!

Thank you very much for the reply, I'm going to give that a shot here shortly.

I have been trying to solve this issue forever with zero luck, I have searched high and low! Basically I would like to control multiple tracks (instruments) with 1 "MIDI fx" plugin (arpeggiator) controlled by my MIDI controller. (MIDI CONTROLLER)~~>>~~(midi fx Arpeggiator)~~>>~~(Multiple instruments)