Hey, all - I know this is a well plumbed area of discussion. I apologize and I am posting this only as a last resort, as I've researched the topic on this and other sites and still cannot resolve the issue I'm having. My panning is not working in Logic Pro X 10.3.2. Previously, it was coming and going, but now it's decided to stay away. I've quit, restarted, started a new project, etc., to no avail. I've run down the stereo, balance, binaural options; I've switched tracks from mono to stereo; I've played with buses/sends, pre-fader, post fader, etc. I've tried it on software tracks and audio tracks, imported audio files, etc. Nothing. The the individual tracks, bus tracks, master output, etc. will not pan. Instead, when I manipulate the pan pot, I just get kind of a wobble in the sound. I've checked and unchecked the pan law. I'm using a Focusrite 8 pre thunderbolt. It comes with Focusrite control and I've checked the settings there and don't see a problem. Interestingly, the aux and stereo out meters register that the signal is being panned, it just sounds straight up the middle. To an extent, I'm kinda glad I'm being forced to pre-mix in mono, but I'd like the option of some width! Any help would be greatly appreciated. Thanks!