greengo

Logic is glitching when I record automation lanes with the mouse. When I put the channel in automation write mode and move a parameter with my mouse, the points of automation lanes become distant from the other, resulting in squares lines when I fast move the parameter. If I record the automations moving the parameter with a controller fader or knob instead a mouse or notebook trackpad, the points of automation lines become perfectly closer resulting in smooth lines even if I move the parameter very fast, and even I'm in a heavier logic project. You can see the automation lines in the image below the orange lines are made with mouse and the others with a midi controller (the orange lines was made moving a XY plane in fabfilter pro Q). I realize that this problem is most intense when I in a heavier logic project and when I try to move two parameters at same time in a XY plane (ex: logic eq, fabfilter pro Q), but when I try to do the same thing in a new project the result is better (not so closer than with a controller, but it's good). I'm using a Macbook Pro Retina i7 2.3ghz 16gb mem Mac OS Sierra 10.12.6 and Logic 10.3.2 Is there some thing to reduce the latency of automation capture when I using the mouse? Its possible to increase the capture of automation points?

Thanks a lot! Would be cool if we can choose 2 different controllers for AQA (ex: a fader and a knob) So we have option to control a specific channel automation with a fader and in next time I can use a knob to control other automation. But it can easy made by reassign a AQA. Thanks again!

Thank you so much. This was so helpful! I have other question. Every time that I try to set a second control for automation quick access it's overwrite the previous assignment. Is it possible to assign more than 1 control for automation quick access?

Hi I'm trying to toggle between Automation Quick Access learned parameter and default controller assignment. I'm using Logic 10.3.2 and Presonus Faderport. When I activate Automation Quick Access, I need to assign a controller command, in this case I want to assign the fader of presonus faderport. So I have a message: This control is already assigned to another parameter. Do you want to reassign the control? I have two option, I can reassign the control and lost the default function of the presonus faderport fader thats control my logic mixer, or I can keep both parameters for the same control so when I move the automation quick access parameter it will move the volume of the channel at the same time. What I need is keep both parameter but when I toggle to Automation Quick Access on, I need that disable the default parameter, so when I toggle Automation Quick Access on I will can move only the automation parameter and when I toggle it off I will can move only the default parameter. It's possible to make it?

Where can I find the file com.apple.logic.pro.cs on OS Sierra? I'm running Logic pro 10.3.2.