Hi all,
Following up with the automation bug that has been previously reported with Mackie HUI protocol (viewtopic.php?t=129390)
I am using iCON QCon Pro X, firmware v. 1.14. In the empty project, automation is fine. In the normal DSP-heavy project, touch and latch (and sometimes write) modes behave abnormally. Looks like the communication is broken. Touch mode snaps to previous value and doesn't capture fader movements, resulting in only 1-2 nodes and averaging across them. The Latch mode jumps back and forth between the baseline value and the current fader value, instead of capturing the new baseline.
If mouse is used for automation, all works well.
Here is the video depicting the problem: https://www.dropbox.com/s/u87a3lifpb0rynh/Automation%20Bug.mov?dl=0
The automation is also out of sync (visible on the video, automation writing happens ahead of playhead)
Has anyone been able to solve this?
Thanks a lot in advance!