Hi,
I am trying to sync Logic to Protools. I have it all going, transmitting MTC thru an IAC midi driver. Audio coming back into Protools thru a Loopback buss.
Set up is in accordance with normal syncing practices in both Logic and Protools.
I am generating MTC from Protools: when I push start, Logic starts and follows along correctly with the expected tiny lag time at startup.
My problem is that if I set loop points in Protools from say, bar 5 to 9, and then push play, Logic will play from the MTC found at bar 5 but when Protools gets to bar 9 and cycles back around to play from bar 5, Logic just continues on, playing past bar 9 into 10, 11, 12, etc until I press stop.
It is behaving almost like it is freewheeling.
My goal is to have Logic follow Protools loop points.
Ideas?
Thanks!