Cant seem to change the midi values on Nanokontrol

I've noticed when I move the faders on the org the midi channel is 0 instead of 7, 1 instead of 11, and 2 instead of 1

 

I've tried to use the Korg editor to correct this but I seem to be getting nowhere

I program the midi numbers but it seems to have no affect when using it in logic (still says midi 0 midi 1 etc)

Is it because of a conflict?

I know the editor is a bit wonky on Big Sur but its worked fine until now

 

Drew

 

I did notice the volume slider on my Keystation is transmitting midi channel 7

 

EDIT:

 

Never mind because I am an idiot.

(I have to write scene data in Korg Editor software)

 

I'll keep this validation that I am an idiot up in case someone else has the same problem and wants to save face.

 

Drew AKA He Who Carries Shame

It sounds like you are not correctly editing the messages the Korg sends, and saving that layout back to the device, as it's not changing it's value. Or perhaps you have the wrong scene selected in the NanoKontrol.

It sounds like you are not correctly editing the messages the Korg sends, and saving that layout back to the device, as it's not changing it's value. Or perhaps you have the wrong scene selected in the NanoKontrol.

 

You are correct. I wasn't clicking on "Write Scene Set".

 

I was clicking save but I didn't know the second step

 

Got it now, thanks.

 

Drew