tusitala Posted May 4, 2017 Share Posted May 4, 2017 Hi, in the project synchronization settings i wanted to have bar 10 playing at timecode 01:00:00:00, but Logic only allows me to select up to bar 9 and not past that... is it normal behaviour or a bug? thanks! -t Quote Link to comment Share on other sites More sharing options...
Eric Cardenas Posted May 29, 2017 Share Posted May 29, 2017 It works fine here. Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted May 29, 2017 Share Posted May 29, 2017 It works as expected here too. Do you already have a movie file in the project? If yes, then try to remove the movie file, set your sync settings, then import the movie? Quote Link to comment Share on other sites More sharing options...
tusitala Posted June 3, 2017 Author Share Posted June 3, 2017 Thank you very much Eric and David... You are right this doesn't happen anymore in a new project, it was only that one. I cannot remember which project i had that specific issue so I cannot try it but I'm sure I already had the movie file loaded, so I guess your suggestion David would have done the trick. Thanks again for your help! All the best -t Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted June 3, 2017 Share Posted June 3, 2017 You're welcome! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.