Jump to content

Mono to Stereo


lordbergfelix
Go to solution Solved by Ploki,

Recommended Posts

Hey,

 

I was wondering if there is any stock plugin besides "gain" in Logic X that I can be able to automate the mono signal from 0% to 100% Stereo. I want a fully dry mix (mono) before the drop then in the build up I want to open up the stereo image with automation (get more impact in a mix), you get the picture?

 

Sincerely,

Felix

Link to comment
Share on other sites

  • Solution

If you want to do it on the whole mix, its much better to do it on the stereo bounce than on the mix itself (less parameters to automate), else route everything you have to a common aux then automate Stereo pan on the said Aux.

(or if you're a masochist you can do it on each track separately)

 

You have to right click the pan knob and select "stereo pan" (instead of default Balance), and with stereopan you can control the "width" of the stereo image.

 

you can also use "Direction mixer" but its essentially identical.

Link to comment
Share on other sites

  • 3 months later...
  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...