mjteigen Posted November 14, 2019 Share Posted November 14, 2019 Hello...this is kind of difficult for me to explain. Hopefully I can do it @_@ I have a piano track I made to work with the arpeggiator. Every other measure it has a series of stacked notes on it (a chord or tone cluster or whatever). During playback, the arpeggiator (in transpose mode with latch turned on) sees these note stacks, and arpeggiates them. Then after a half measure a new single note appears on the piano MIDI track, telling the arpeggiator to play that same arpeggiation at a different pitch. Another half measure goes by and a new note transposes the arpeggiation. And again. Then, a new note stack appears, giving the arpeggiator new notes. This new stack is re-pitched a few times. Etc. Here's my problem: I want this piano track to stop entirely so I can do something else in my song. But the arpeggiaotr just keeps on going with its last assignment, and won't stop. Is there some way to put in a "stop" command, or something, so I can silence this track? I realize I can just press either the latch button or the play button on the arpeggiator during playback, but this doesn't help me when bouncing the track to a final mp3. In that case, with my current knowledge I'm stuck playing that last arpeggiation for all eternity. Hope this was somewhat clear...thanks in advance. Quote Link to comment Share on other sites More sharing options...
Atlas007 Posted November 14, 2019 Share Posted November 14, 2019 Have you tried using automation? Quote Link to comment Share on other sites More sharing options...
mjteigen Posted November 14, 2019 Author Share Posted November 14, 2019 Thank you, I'll look into it. I would still certainly welcome other specific solutions though. Quote Link to comment Share on other sites More sharing options...
Atlas007 Posted November 14, 2019 Share Posted November 14, 2019 AFAIK, I don't think there are other simpler solutions... Quote Link to comment Share on other sites More sharing options...
mjteigen Posted November 14, 2019 Author Share Posted November 14, 2019 I'm sure that's true. Forgive me, my knowledge is limited. I think automation is what I need. Thanks again. Quote Link to comment Share on other sites More sharing options...
Atlas007 Posted November 14, 2019 Share Posted November 14, 2019 I didn't mean to be rude. Just voicing an opinion to save you time... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.