Gianni_Gon Posted April 21, 2021 Share Posted April 21, 2021 What do you do in case you have a region where the waves of the vocals are too thin, and you cannot flex time them because the transients can be barely distinguished? Quote Link to comment Share on other sites More sharing options...
triplets Posted April 21, 2021 Share Posted April 21, 2021 Increase the gain in the File Editor, which is destructive. Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted April 22, 2021 Share Posted April 22, 2021 Or you can use the Gain in the Region inspector which is non-destructive: Quote Link to comment Share on other sites More sharing options...
Gianni_Gon Posted April 22, 2021 Author Share Posted April 22, 2021 Thank you both (: I like to be non-destructive That is very helpful, cause I see the waves increase in height. No change is meant to be done, only identifying transients. Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted April 22, 2021 Share Posted April 22, 2021 You're welcome! Note that there's also a waveform zoom slider, which does not change the gain of your regions, however it applies to all waveforms in all your audio regions in the project: Quote Link to comment Share on other sites More sharing options...
Gianni_Gon Posted April 22, 2021 Author Share Posted April 22, 2021 Cheese! You can slide that thing! Haa I got it! Thanks Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted April 22, 2021 Share Posted April 22, 2021 You're welcome! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.