ColbyKeyz Posted October 22, 2021 Share Posted October 22, 2021 Hi I have managed to get around latency issues by using 1024 buffer and plug in latency (both options) . But whenever I use the UAD Pultec plugin it ruins my project because it will cause instruments to be delayed. I have an apollo twin pls help Quote Link to comment Share on other sites More sharing options...
des99 Posted October 22, 2021 Share Posted October 22, 2021 All UAD plugins cause a large amount of latency, inherent in that they have to shuffle audio between the DSP card and the DAW both ways. However, plugin compensation will take care of this while mixing (assuming you have this set to "All"). If you're still tracking with UAD plugins in your session, you may get headaches, but Low Latency Mode should help. Quote Link to comment Share on other sites More sharing options...
ColbyKeyz Posted October 22, 2021 Author Share Posted October 22, 2021 It is set to all I still have latency. Im not tracking im mixing Quote Link to comment Share on other sites More sharing options...
des99 Posted October 23, 2021 Share Posted October 23, 2021 You will still get latency if you have plugins that induce latency on busses or outputs, because Logic has to push the signal back to compensate. Tracks don’t get pushed back in the same way because Logic can pre-read the data, but busses and outputs can’t be done in this way. However this doesn’t “ruin” a project. What is the problem you are having exactly? Quote Link to comment Share on other sites More sharing options...
ColbyKeyz Posted November 5, 2021 Author Share Posted November 5, 2021 It makes my melodies off time. Quote Link to comment Share on other sites More sharing options...
defkam Posted November 7, 2021 Share Posted November 7, 2021 Hello, What is the amount of the limit cursor you have chosen for the plug-in latency "Low latency mode"? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.