SoSpiro Posted October 26, 2021 Share Posted October 26, 2021 i'm trying to streamline my automation and have all 8 knobs available to 8 different tracks. As of now, in MCU mode (using my Maschine MK3), knob 1 only controls the selected tracks volume fader, then knob 2 controls the same tracks panning, and the rest are controlling god knows what...the hardware just scrolls through plug ins when they're moved, but nothing happens in my DAW. i posted this in the maschine forum and they said the following, but i don't know where to change these options: "Sounds like you are in Single Channel Mode. I am not sure what Logic Calls it, but it might be called "Assign Track". it is MCU Parameter ID 40. I dont have Logic, so cannot confirm, but in Cakewalk, that puts it into Single channel Mode." Quote Link to comment Share on other sites More sharing options...
danyg Posted October 27, 2021 Share Posted October 27, 2021 did you do a proper installation? Quote Link to comment Share on other sites More sharing options...
SoSpiro Posted October 27, 2021 Author Share Posted October 27, 2021 did you do a proper installation? I'm sure I did, as this was never a problem for me until recently. However, I'll recheck this. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.