IvanCh Posted December 3, 2021 Share Posted December 3, 2021 Hello, I have an issue with cycle looping recording. I want to hear my takes during my next record in loop. How can I activate it? Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted December 3, 2021 Share Posted December 3, 2021 Audio or MIDI? Quote Link to comment Share on other sites More sharing options...
IvanCh Posted December 3, 2021 Author Share Posted December 3, 2021 Audio Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted December 3, 2021 Share Posted December 3, 2021 Unfortunately that's not possible in Logic. Quote Link to comment Share on other sites More sharing options...
IvanCh Posted December 3, 2021 Author Share Posted December 3, 2021 Okay, maybe I can create several cells in live loops and program it for start recording next cell when previous is done? Is it possible? Quote Link to comment Share on other sites More sharing options...
Solution David Nahmani Posted December 3, 2021 Solution Share Posted December 3, 2021 Okay, maybe I can create several cells in live loops and program it for start recording next cell when previous is done? Is it possible? I don't believe that's possible unfortunately. To do what you want you would need some kind of looper plug-in. Quote Link to comment Share on other sites More sharing options...
polanoid Posted December 3, 2021 Share Posted December 3, 2021 If you can live with one cycle run of not recording anything in between two recordings, and using 2-3 key commands, you could do the following: 1) select an audio track, open live loops grid, make sure no cell is selected 2) In the cell inspector, which should now show "Audio Defaults", set the desired loop length (and set cell length to the same value), set Rec-Length to "Cell Length" and At Rec-End to "Play" (you may have to click on the little ">" signs before "Play From:" and "Recording:" to reveal those parameters) 3) Right-click on a cell, choose "record into cell" (you may want to do this with Count-in active) 4) Record your audio. Cell will change from Record to Play mode after the chosen Cell Length 5) while the recorded cell is playing, press Cmd-D to duplicate the audio track. This will also select the newly created track. 6) you may want to disable count-in now by pressing Shift-K 7) as soon as playback is somewhere in the last bar of the already recorded cell, press Option-R to start cell recording again 8) repeat from step 4) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.