Jump to content

Can't preview Apple Loop during playback in Live Loops?


David Nahmani

Recommended Posts

Hi David,

Of course you wouldn't have inadvertantly left your volume slider on 0? (Easy enough to do)

 

I wonder if it could be something to do with different loop types either playing with each other or with another group? (green, yellow, blue etc)

 

For my test I just pulled in "12 String dream 01" (green) to live loop cell and played one of the other green loops in that batch. That was fine

 

Then I just chose to play a blue loop "2- Step backflip beat 02" (blue) to play with said live loop and that was fine.

Link to comment
Share on other sites

No, it's not the volume slider, the playhead doesn't even appear on the waveform at the bottom of the loop browser.

 

I put "Je Danse Kick" in a cell and then play it, and I can't preview any other loop. I reproduced this on two machines.

 

Well sure enough, now that I try again, it works just fine. Go figure. :roll:

 

Thanks for your help! :)

Link to comment
Share on other sites

Works flawlessly over here following your steps and 'Je Danse Kick'.

Thanks a lot for giving this a try André.

 

So what I ended up figuring out was that it works only there's no visible playhead appearing on the waveform display at the bottom of the Loop browser, as there is normally when you preview a Loop when the project is stopped.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...