Bounce Real Mono out of Logic

I been try to bounce out real mono as a wav

 

When I been taking the mono bounce file from logic and open up QuickTime player it says it still in some kind of stereo

 

What is the step by step to bounce audio to mono ?

 

Thanks

The output channel that you bounce from must be set to mono. Also, you need to actually click the bounce button, as the key command always bounces the Stereo Out.

Somehow you need to bounce a mono signal in order to produce a mono file. If you're bouncing the project or a section of the project then you need to follow Christian's advice above. You know you're bouncing a mono file when you're bouncing only one single output, as per the title of the Bounce dialog:

 

 

If you're bouncing an audio signal in place then that audio signal needs to be a mono one: you need to make sure that either the channel strip's output is set to a mono output, or that the last plug-in on the channel strip is mono and you're not including volume/pan automation (or if you don't have any plug-ins, then the input format of the channel strip needs to be mono).

Ok I got a stereo file in real Mono and check with QuickTime info inspector and its definitely mono

 

Thanks guys

You're welcome!