dubsak Posted May 12, 2020 Share Posted May 12, 2020 Not sure if anyone else is seeing this. With my interface (Apogee Ensemble), every channel strip with an audio input would show: pre-amp gain, phantom power, high-pass filter and polarity inversion. As of Logic Pro X 10.5, these controls have gotten messed up. Setting up the Channel Strip Components to show "Audio Device Controls" will show and allow me to adjust gain but then hides phantom power, high-pass filter and polarity inversion. Clicking to show Audio Device Controls again, reveals phantom power, high-pass filter and polarity inversion but does not display gain control and further, when you attempt to select or deselect "Audio Device Controls", it remains selected (checked) regardless. Quote Link to comment Share on other sites More sharing options...
blackgreygrayblay Posted May 15, 2020 Share Posted May 15, 2020 Mine shows up just fine. Can you check Ensemble firmware version? Quote Link to comment Share on other sites More sharing options...
dubsak Posted May 16, 2020 Author Share Posted May 16, 2020 Mine shows up just fine. Can you check Ensemble firmware version? To be clear, this is just in the Inspector, not the mix window which shows everything just fine. Can you confirm that it's displaying properly there for you? Firmware is 1.5.3 Thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.