maintitle Posted August 16, 2013 Share Posted August 16, 2013 When I double click a transformer that is inside a macro I created to make a change to it's parameters, it's window appears for a split second then disappears completely. The only way I can change the transformer's parameters is to unpack the macro and re-pack it. Big pain. Anyone else verify this bug? In LP9 this worked fine. Quote Link to comment Share on other sites More sharing options...
ski Posted August 17, 2013 Share Posted August 17, 2013 I'll try and verify this behavior for you later this evening. Quote Link to comment Share on other sites More sharing options...
maintitle Posted August 17, 2013 Author Share Posted August 17, 2013 I'll try and verify this behavior for you later this evening. Thank you, ski Quote Link to comment Share on other sites More sharing options...
Eric Cardenas Posted August 17, 2013 Share Posted August 17, 2013 I can confirm. Most scary thing above all is this... I created a new transformer and did not set any parameters. Packed it into a macro. Double-clicked on it and took a screen shot of the transformer window before it disappeared. This is what I got: Quote Link to comment Share on other sites More sharing options...
ski Posted August 17, 2013 Share Posted August 17, 2013 Couldn't wait 'til later... I can confirm, this behavior is bugged: And as a little etymological side note, the progress bar relating to a really short recording I made several hours earlier is still barberpole-ing off to the side (scroll down or click on the picture to see it). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.