esaruoho Posted June 24, 2015 Share Posted June 24, 2015 Hi, I'm trying to figure out how to use the LPX Midi Environment to create a button that would start playback. I already have a button that sends a Meta Fader event #52 which stops playback. My initial hope is to create an environment that allows me to use my LPD8's Knob to run it so that anything over 100 starts playback and anything below 100 stops playback (a single start-stop knob). My setup does not afford me the possibility of using the pads in the LPD8 so I'm just using a minimal setup, one knob to control pitchbend, one knob to control some arpeggiator rates and one knob to hopefully start and stop playback. Can ya help? Link to comment Share on other sites More sharing options...
Eric Cardenas Posted June 24, 2015 Share Posted June 24, 2015 I would set the hardware knob to send values between 1 and 2. Then learn the key commands Play and Stop separately so that the respond to 1-2 and 0-1. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.