Jump to content

bounce region picks wrong start and end point


Recommended Posts

As you can see by the screen shot, I have a region selected. But when I select bounce cmd-b, it picks a seemingly random measure range to bounce. What am I doing wrong? It used to pick the region range automatically. Thanks in advance. Screen Shot 2018-09-14 at 9.16.29 PM.png


I used to get that problem too ronwass, even when typing in the start and end points, now I just do as triplets says, create a cycle range, make sure it set a bit later than the audio regions end to include any tails of reverb or whatever.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...