Getting rid of velocity sensitivity on Logic's Sampler instrument [SOLVED]

[madhopper]

Hi,

Does anyone know how to make samples in the Sampler always fire at full velocity ? I want to be able to strike a key and get the full volume of the sample, irrespective of how hard I press the key.

Any guidance would be great! Thanks.

[des99]

In the Modulators section, for ENV1 AMP, turn the "Vel" slider to minimum.

[madhopper]

That's great. 

Thanks so much, des99.

[Atlas007]

Alternately you could try using the track parameters:

• Velocity value slider: Click and hold the area right of the parameter name, then drag to increase or decrease the velocity for notes in all regions on the track.

• Key Limit value slider: Click and hold the lower or upper key value, then drag to change the value. The two values together define the key range; any notes outside this range are not played.

• Velocity (Vel) Limit value slider: Click and hold the lower or upper velocity value, then drag to change the value. The two values together define the velocity range; any notes with a velocity outside this range are not played.

or the Velocity or Dynamics region parameters:

• Velocity: All notes in the relevant MIDI region are offset by the selected value. Positive values add to the originally recorded velocity, and negative ones subtract from it, although naturally it is impossible to go outside the limits defined by the MIDI Standard (0–127). If you select a velocity offset that exceeds the maximum or minimum possible value for a particular note, that note will play at the extreme possible range. For example, a setting of +20 will cause a note with a velocity of 120 to play at 127.

• Dynamics: This parameter also affects the velocity values of notes, but instead of adding or subtracting a fixed amount, the differences between soft and loud notes (the dynamics) are increased or decreased. This works in a similar way to a compressor or expander. Values above 100% expand the dynamics, thereby increasing the difference between loud and soft, while values below 100% compress the dynamics, reducing the differences between loud and soft.

  The Fixed setting causes all notes to be transmitted at a velocity value of 64. When used in conjunction with the Velocity parameter (see above), it’s possible to set any fixed velocity value.

or use the Modifier MIDI Fx.