Eric Wikman Posted December 18, 2007 Share Posted December 18, 2007 I can't seem to figure this out. Most of the time, I use a bus and it's set to no output, but some other times I need to open the Environment, create the bus I just assigned, and set it's output to "none/off". What am I missing? This is in Logic 8. Link to comment Share on other sites More sharing options...
Eric Wikman Posted December 19, 2007 Author Share Posted December 19, 2007 Bump. Anyone have any insight to help. Sometimes the Busses seem to be set to Outputs 1 & 2.. and most the time set to no output? How can I avoid having to create a bus.. to turn it's output off? What simple thing am I missing? Link to comment Share on other sites More sharing options...
fader8 Posted December 19, 2007 Share Posted December 19, 2007 Deep, I'll have to confirm this, but I think if you use a bus without creating a bus object in the environment, then it defaults to No Output as it expects you'll pick it up on an aux. If you create the actual object, it defaults to your first 2 outputs. Link to comment Share on other sites More sharing options...
Eric Wikman Posted December 19, 2007 Author Share Posted December 19, 2007 Hey Fader8.. always helpful! You are probably right, but I only have "created" a bus in the Environment when I seem to hear output from a bus... and then saw it was set to output 1&2..., but I could be wrong about how & when I first used it. I need to look into it some more, as yesterday, I could not get a bus to be set to an output w/o making it that way. Thanks again. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.