Jump to content

Troubles with Bouncing


SillrayTV

Recommended Posts

Check your start and end points.

 

I usually Select All (command A), then Set Locators. This should automatically select the correct start and end points for bouncing.

 

I avoid starting at 1 1 1 1, as it used to cause popping or silence at the beginning of the audio file in L7. This may have been fixed in L8, but its now just a habit.

 

Don't forget to extend the end point if you have delay or some similar kind of effect that tails off at the end of the track.

 

If all your getting is silence, make sure all mutes are off and your not in solo mode.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...