jayendra Posted August 12, 2008 Share Posted August 12, 2008 I have 3 firepods that link together. I have the bass guitars going through a bus which then goes out through 3&4 (sub). How do I them go through 1&2 (regular stereo) and 3&4 (sub) outputs? I have a software crossover I want to put in the middle as well. thanks - Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted August 12, 2008 Share Posted August 12, 2008 Seems to me like you've already done all the work? Just send to that bus to send to the subwoofer, and the main fader for the tracks that output to 1-2 will determine the level that is sent to 1-2. You can add a low-pass on the sub aux, and a hi-pass on the Out 1-2 channel strip. Quote Link to comment Share on other sites More sharing options...
jayendra Posted August 12, 2008 Author Share Posted August 12, 2008 thanks again david!! I got ya - send - sub output - 1&2 coolio - do you think that low/high filter will be good to crossover low/high playing on the bass? Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted August 12, 2008 Share Posted August 12, 2008 low/high playing? Crossover filters will separate frequencies, not notes. A low bass note may have its root pitch below the crossover frequency, but it still contains tons of harmonics and transients that are going to be above the crossover freq. Quote Link to comment Share on other sites More sharing options...
jayendra Posted August 13, 2008 Author Share Posted August 13, 2008 Just a quick question - Can I have a bus that will adjust the main speakers and the sub - for bass only? So Bass Output to bus 1 (bass) send to bus 2 (bass sub) then bus 1&2 output to another bus (bus 3) which controls both volume for the sub and speakers. logical? or is there an easier way Quote Link to comment Share on other sites More sharing options...
jayendra Posted August 29, 2008 Author Share Posted August 29, 2008 Dig up this post - I'm still trying to get the whole mix through outputs 1&2 and the sub. I had a plugin with energyxt - which I could drag a cable from the 3 outputs of the crossover plugin - 2 to the stereo out and 1 to the sub. this was it http://www.kvraudio.com/get/3144.html I'm looking for a plugin that will do this in logic and a way to implement it. Jay Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.