sykesoz Posted September 17, 2009 Share Posted September 17, 2009 In Logic 8 and 9 when recording projects longer than an hour the time measurement (from bar and time, bar, time etc) goes from 59 minutes to 2 hours missing out the 2nd hour. This doesn't effect performance but it's a little odd. Has this happened to anyone else? Link to comment Share on other sites More sharing options...
fuzzfilth Posted September 17, 2009 Share Posted September 17, 2009 Not here. Perhaps it happens only in a leap year ? Christian Link to comment Share on other sites More sharing options...
Tankfield Posted September 17, 2009 Share Posted September 17, 2009 In Logic 8 and 9 when recording projects longer than an hour the time measurement (from bar and time, bar, time etc) goes from 59 minutes to 2 hours missing out the 2nd hour. Logic misses out the 1st hour. Bar 1 starts at 1h 0m 0s etc, not at 0h. The timeline doesn't display the hour digit until 2h 0m 0s comes up. This is a hangover from when analogue tape machines would sometimes wind back past 0h 0m 0s, read timecode of 23h 59m etc and then try to rewind even further to get back to 0 and of course the tape comes off the machine, distracting the tape-op who should be making the tea & coffee. Link to comment Share on other sites More sharing options...
zoff Posted September 17, 2009 Share Posted September 17, 2009 In Logic 8 and 9 when recording projects longer than an hour the time measurement (from bar and time, bar, time etc) goes from 59 minutes to 2 hours missing out the 2nd hour. This doesn't effect performance but it's a little odd. Has this happened to anyone else? Control-click the time display, select Use SMPTE View Offset. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.