hungrydave Posted August 21, 2012 Share Posted August 21, 2012 Say you have a cycle over bar 1-8. Logic plays any note on beat 1 of bar 9 over the top of beat 1 bar 1. How do i switch this off? Link to comment Share on other sites More sharing options...
triplets Posted August 21, 2012 Share Posted August 21, 2012 Make sure there's no overlapping notes or notes that start a tiny bit before the downbeat. Link to comment Share on other sites More sharing options...
hungrydave Posted August 21, 2012 Author Share Posted August 21, 2012 yeah, i checked that very thoroughly, i think there's some look ahead/chase events setting type thing going on Link to comment Share on other sites More sharing options...
hungrydave Posted August 21, 2012 Author Share Posted August 21, 2012 ok, it's stopped doing it now after a re-open. Maybe just a glitch Link to comment Share on other sites More sharing options...
ski Posted August 21, 2012 Share Posted August 21, 2012 Logic is glitchy in this way. And the behavior may change on its own too. Having notes overlapping from one measure into the next is, of course, not a problem for your music but it does make Logic occasionally lose its mind --- all depending on how the various note chase settings are set up, and, the randomness that is Logic when it comes to this kind of thing. Link to comment Share on other sites More sharing options...
TED209 Posted December 24, 2012 Share Posted December 24, 2012 I'm using a synth (podolski, free and recommended, simple and sounds great) with an arpeggiator and this is doing my nut. If you reopen logic it is fine until it I take it off loop and let the piece continue. Then if you return to cycle mode, there is some sort of look ahead going on where it reads the next bar after the loop and the arpeggio is triggered. No overlapping notes etc. Very odd. I'm going to try and move some notes around, grrrr Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.