jspitza Posted September 15, 2012 Share Posted September 15, 2012 Good morning all! This is my first post and I'm very excited to see just how far behind the times I am using my trusty duel g5 running tiger, logic7 pro and a new focusritepro 40. Everything is working well with the DAW default setting and logic is routing both inputs and outputs fine. My previous interface was the firepod which did not use any mixing software. i need to route any and all Logic audio channels to output 3/4 which goes to my kaoss pad for processing and return it to Logic inputs 7/8 on a armed recording track back into Logic(which then routes back to the main outputs 1/2. I was using this configuration with the firepod with no problems. I have attached the my current setup attempt and can't get the input back into inputs 7/8 from 3/4 output. I think the problem is this dam mixing software but need some help. If anyone would be so kind as to review it I would be very grateful. Take care and happy Saturday. Jeff Link to comment Share on other sites More sharing options...
David Nahmani Posted September 16, 2012 Share Posted September 16, 2012 First thing: does the Korg Kaoss receive Logic's output? Does it have a headphone jack you could use to check? Link to comment Share on other sites More sharing options...
jspitza Posted September 16, 2012 Author Share Posted September 16, 2012 Good morning David. Let me check in a few minutes. Link to comment Share on other sites More sharing options...
jspitza Posted September 16, 2012 Author Share Posted September 16, 2012 Ok. I've checked the output of 3/4 and no signal is being received in the Korg. I even used the IO plug and connected a hardware efx unit just to be sure and the efx unit does not receive any signal either. So no, I can't get anything other than master outputs 1/2 from Logic. All focusrite setting are defaulted to DAW which is supposed to be used for DAW control over all ins and outs. I'm not using any other MIX functions. I'm stumped. Link to comment Share on other sites More sharing options...
triplets Posted September 16, 2012 Share Posted September 16, 2012 Analog In 7 to Line Output 3? That doesn't make sense. Should be Output 3 to Line Output 3 or something similar. What other options besides Off? Link to comment Share on other sites More sharing options...
jspitza Posted September 16, 2012 Author Share Posted September 16, 2012 Thank you to all of you for your time! Well, it took me some searching but I found this nifty little article that answered my questions. As I figured, a very simple switch and viola! http://www.focusrite.com/answerbase/en/article.php?id=1094 Take care, Jeff Link to comment Share on other sites More sharing options...
David Nahmani Posted September 17, 2012 Share Posted September 17, 2012 Great! Thanks for updating this thread with your solution. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.