Jump to content

Record stops after 1 cycle [SOLVED]


Soundhound

Recommended Posts

Was doing some vocal recording yesterday and all of a sudden (near the end of the session, thankfully), Logic started to only do one cycle of recording. Meaning I had loop set, and when it got to the end of the loop cycle and started over again, it would keep going, but no longer be recording,

 

I've never run into this before and have looked around in the manual etc for a setting that I might have changed, but haven't found anything so far. I couldn't tell if this was a glitch, or I'd unknowingly changed a setting somehow. Come to think of it, we were doing long takes most of the session, and I notice this only when we started doing some cycle takes near the end. Maybe this had been going on for a while and I didn't notice till then.

 

Anyone know of what setting might be causing this? thanks!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...