Jump to content

Select Regions on Track Selection misbehaving


Eriksimon

Recommended Posts

Select regions on track selection is not working properly, (LP X.0.1). It selects one or several, but never all regions on track, both on SI and on audio tracks. It doesn't matter if it is on or off - when it's off it is supposed to happen when selecting the track with alt pressed. In both scenarios it doesn't work; the same few regions get selected eitherway. Confirmations andor falsifications are appreciated. As is filing a bug report. http://www.apple.com/feedback/logic-pro.html

 

1507874624_pic2013-07-26at12_29_31.PNG.14fd79869d3256f150435dcd3ae67795.PNG

 

1449969537_pic2013-07-26at11_11_19.PNG.6689a8366190aa9fc084ebcb911035d8.PNG

 

1289170836_pic2013-07-26at11_10_50.PNG.688366f69e1619c9d4083bfb744b14a8.PNG

 

760022810_pic2013-07-26at11_11_07.PNG.c50ec7ec4d752428805dd46bee33f727.PNG

Link to comment
Share on other sites

No, no cycle, and the screens are all from the same project. I now recall having seen this in LP 9 too - but I rarely used the command anyway, so I'm not sure if it is just a "migrated" LP 9 bug... or perhaps a sign of impending project corruption... :(

I'll open another project, see what happens there...

 

 

Later added:

May have been Pilot error-ish: it is the project I originally made to test negative-bar corruption thingies (after a sceptical reaction from user Bruce (aka Data Stream Studio), who claimed it was a "myth"), it used to start at bar -(minus)3, and sure enough: the playhead is now also in the wrong place :? :roll: :?

 

1025040318_pic2013-07-26at13_27_05.PNG.43c04902f34885c9b92c75874750b962.PNG

 

...and select regions on track selection now suddenly works again (without having closed the project, just did some region shuffling.)

 

I'm going to create a fresh project... :(

 

Something tells me .0.2 may be around the corner...

Link to comment
Share on other sites

is the project I originally made to test negative-bar corruption thingies (after a sceptical reaction from user Bruce (aka Data Stream Studio), who claimed it was a "myth")

Give me 5 seconds and I can show Bruce unexpected behavior in Logic Pro with the project start at any place other than 1 1 1 1 (everyone talks about negative bars, but the issue is also with values between 0 1 1 1 and 1 1 1 1, and with values above 1 1 1 1) on any Logic rig. :wink:

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...