Jump to content

Hap hazard pitch bender issue


Natasha0404

Recommended Posts

Hi all,

 

Just out of the blue, my pitch bender has changed settings by itself. When i pitch up, the sound does bend +2 notes up, but when i pitch bend down, the pitchbends +1 !!! I have tried to re-learn the controller but it still doesn't work like it used to.

Link to comment
Share on other sites

Hi. Thanks. Yea, i have not changed any of these settings. They've always been 2 and 2 on both ends. It is very strange. When i am in the layout mode, i tried to learn the bender again as the pitch bender but for some reason the issue is still there.
Link to comment
Share on other sites

  • 2 weeks later...

Hi

 

Sounds to me like you need to verify that the keyboard bender knob/wheel hardware is working correctly, and then track down the issue to find where the fault is:

 

 

1) In a brand new Concert, does the bender work correctly?

 

You should see the following messages in the MIDI activity area in MS3:

104553380_BenderDown.jpg.e1c5cb3721a1f91eaa398fa5849648aa.jpg514251548_BenderUp.jpg.9c6e88fbadf248a59d680f17f8bba31b.jpg

 

2) In GarageBand (if you have it installed) does it work?

 

CCT

Link to comment
Share on other sites

I own an Axiom 61, so I tested the pitch ben issue that you mention, and everything ok here.

 

Axiom Pitch bend CC is nr 144

 

In order to check the amount of your pitch bend setting, proceed like this

1 - move your pitch bend

2 - press button DATA 3 (MAX) in my key value shown is 127

3 - press button DATA 2 (MIN) in my key value shown is 0

 

probably in your DATA 2 there's a value higher than 0

 

you can alter those value just pressing + and - of axiom top left numeric pad while you see value of Data 2 or 3

Link to comment
Share on other sites

Hi

 

Sounds to me like you need to verify that the keyboard bender knob/wheel hardware is working correctly, and then track down the issue to find where the fault is:

 

 

1) In a brand new Concert, does the bender work correctly?

 

You should see the following messages in the MIDI activity area in MS3:

[attachment=1]Bender Down.jpg[/attachment][attachment=0]Bender Up.jpg[/attachment]

 

2) In GarageBand (if you have it installed) does it work?

 

CCT

 

Hi. When the bender is down, the numbers are 1:92:92. When the bender is up the numbers are 1:127:127.

Link to comment
Share on other sites

yes, so as explained before, you have to adjust the setting inside axiom parameter

 

1 - move your pitch bend

2 - press button DATA 3 (MAX) key value shown is 127

3 - press button DATA 2 (MIN) in your key value shown should be 92

 

press + and - of axiom top left numeric pad and adjust DATA 2 value, setting it to 0

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...