sHERB Posted December 10, 2013 Share Posted December 10, 2013 So I switched to a new computer and a new version of logic. One issue which I can't figure out: When the fader on the mixer is pulled all the way down, the volume goes out BUT the signal is still on the mixer. When I pull the fader all the way up, the volume increase but the signal of the audio stays the same. Pretty sure it's a box to check in in preferences, hopefully, but I can't figure this out. Thanks! Link to comment Share on other sites More sharing options...
Jordi Torres Posted December 10, 2013 Share Posted December 10, 2013 Turn off Pre-Fader Metering (Options > Audio). J. Link to comment Share on other sites More sharing options...
sHERB Posted December 10, 2013 Author Share Posted December 10, 2013 HAH! Thanks Jordi! Link to comment Share on other sites More sharing options...
Jordi Torres Posted December 10, 2013 Share Posted December 10, 2013 No problem! J. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.