logicscott Posted November 14, 2006 Share Posted November 14, 2006 Has this happened to anyone? Out of the blue, Logic can't see any of my V.I.s or plug ins. It doesn't matter what session I bring up, Logic immediately loads the session ( I can see all of the waveforms, etc. BUT all of my Plugs/Inst's have a line through them. Help me if you can....Thanks, Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted November 14, 2006 Share Posted November 14, 2006 Check that you have a CoreAudio driver enabled in Audio > Audio Hardware and Drivers ? If you do, disable it and re-enable it, then click 'Try (Re)Launch'. Quote Link to comment Share on other sites More sharing options...
logicscott Posted November 14, 2006 Author Share Posted November 14, 2006 Thanks David..that was it. That's never happened to me before. Do you know what causes it? Quote Link to comment Share on other sites More sharing options...
David Nahmani Posted November 14, 2006 Share Posted November 14, 2006 A recent crash resulting in lost preferences, or if you just replaced your preferences, or used a different interface that you unplugged... there could be many reasons. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.