Jump to content

Unusual Control Surface Behavior On Initial Autoload Opening


Subtonic

Recommended Posts

Hey everyone,

I use a Tascam FW-1082 control surface with Logic Pro. I just upgraded to 7.2 a week ago and there's been some odd behavior when opening Logic.

 

When Logic Pro initially loads my volume faders come up to 0db and the immediately down to the bottom for the 8 channels the control surface loads on (like Audio Tracks 1-8). If I close that session and open a new one using the same Autoload everything is fine. If I exit Logic and start over again the same volume fader behavior occurs.

 

This never happened in 7.1 and I can't think of any reason why it's different now. For troubleshooting I turned off all MIDI controllers (in case one of them had faders mapped to mixing functions) - no change.

 

I think there's something I must be overlooking - unless this is a bug. Any ideas?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...