David Nahmani

that window is listing the different locations where it finds copies of the same samples, so apparently you've saved the sample along with different projects saved on your Dropbox (Wicked, On the Run, This Moment, Young Again, etc...). This isn't necessarily an issue, you can just select one of those, typically the one that corresponds to the project you're loading, and move on with your work. However it's may not be necessary to save multiple copies of the same custom DMD kit, so you could save it once somewhere in your library and then no longer include it for each one of the projects where you use it.

Well then while waiting for kingonort to come back here, did you check that it wasn't a sample rate mismatch? How much transposition, as in how many semitones?

Yes, you can select an automation point and press Option + Up arrow / Down arrow to change its value in fine increments.

Yes, exactly! This allows you to make sure the cell repeats every 4 bars even if the region isn't a full 4 bar long. Or for example to repeat every 2 bars even if the region is 8 bar long.

I get the same here when selecting cells, I suppose it's a bug? If you select a scene and not cells, then the key command works as expected.

Great! You're welcome. 🙂

There may be a program change inside the MIDI region. Select the region and open the Event List, and if there's a program change, try to delete it so that whatever patch you select in your instrument sticks.

How do you choose the instrument exactly?

In that project, you've selected the Bus 2 however the Ultrabeat outputs are not the same as in the original project you had shared! Take the original project you had shared and select Bus 2 in the side chain pop-up menu of the Compressor, don't change anything else, and it will work, as I showed on the animated screen capture I shared earlier.

Ok then exactly which kick drum do you want to use to trigger the compressor's side chain? Because you had a channel selected that wasn't playing any kick drums, I just guessed as to which kick drum you wanted to use. You basically have to select the correct kick drum in the side chain pop-up menu. Oh I think I get it.. you want the Ultrabeat kick to trigger the side chain? Then indeed you need to select Bus 2 in the side chain pop-up menu.

I'm not sure where you're copy/pasted the region or where you're playing back. If I copy your Drummer region to bar 5 and play from bar 5 then the Compressor is triggered as expected. If you feel like you now have it set up right and it's still not working, share the new project and I'll have a look.

As long as the loop length is set correctly in the Cell inspector, then the loop plays 4 bars:

Slowed down by how much? Or tuned down by how many semi-tones? I'm trying to figure out if this is a sample rate mismatch issue.

Good to hear you found a fix. Sometimes I've noticed that Logic can get confused in its plug-in delay handling when I start turning plug-ins on and off during playback, or when Logic is left idle for a while. In these cases, restarting Logic typically fixes the glitch.

How do you listen to the bounced audio file?