crimsonnoise Posted July 1, 2020 Share Posted July 1, 2020 Whenever I record on a software instrument track, and play no notes, Logic creates a 1 bar empty region during the count-in. There is no sysex in there either, no midi at all in the region. When using "drop" then an empty region is created from the point where the track is dropped into record. Problem has only recently started, after trashing preferences. On Logic 10.4.8, in Mojave, Mac Pro Trashcan 8 core. Quote Link to comment Share on other sites More sharing options...
Atlas007 Posted July 4, 2020 Share Posted July 4, 2020 I think that is normal behaviour. Logic creates MIDI region on a per bar basis, being empty or populated. Quote Link to comment Share on other sites More sharing options...
crimsonnoise Posted July 4, 2020 Author Share Posted July 4, 2020 Thanks for the reply. Sorry, I may not have explained this properly. I put Logic into record, and after a few bars stop again. I play no note. There is now an empty region. This is not normal. Or: I start recording on bar 3, but only play midi notes on bar 9. The newly recorded region starts on bar 3. But normally it would have automatically been trimmed to start on bar 9. Quote Link to comment Share on other sites More sharing options...
Atlas007 Posted July 4, 2020 Share Posted July 4, 2020 Perhaps you get some other MIDI data incoming? Have you checked in the Event List editor (with all the selection buttons enabled)? Quote Link to comment Share on other sites More sharing options...
crimsonnoise Posted July 4, 2020 Author Share Posted July 4, 2020 Yes I have checked the event list with all selection buttons enabled. Completely empty. Quote Link to comment Share on other sites More sharing options...
Atlas007 Posted July 5, 2020 Share Posted July 5, 2020 Have you tried with another project template? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.