Automation lane or point via shortcut

[Sir Hannes]

Hi,

in the key command menu, there is shortcut "Transpose region/ event by +1 half-tone or automation by +1 step" (or similar). My Synth-Lane is on +5% and I want to replace this mouse fiddlings to get it to zero, it changes the sound still and this behavior I experience a lot.

I searched for key commands to decrease "steps" and set it to 1/64 and later to a sample. But this doesn't change the behavior. Neither 1/64 nor sample brings mir close to zero, they all stay within +/- 2 increments.

Is the labelling "step" misleading here?

Note: In the German version they use Schritt and Schrittweite, I translate this to Step and Stepwidth, but may vary in the english version. 🙂

 

[polanoid]

7 hours ago, Sir Hannes said:

I searched for key commands to decrease "steps" and set it to 1/64 and later to a sample.

That would be the step width in time, which doesn't apply to value changes of course. AFAICT the step width is fixed to 1/100 of the parameter range for the Nudge Automation Up/Down commands

[Sir Hannes]

Thanks& understand. Another key command to change the parameter ranges isn't available, like "fine-shifting" or "fine-nudging"?

[David Nahmani]

3 hours ago, Sir Hannes said:

Thanks& understand. Another key command to change the parameter ranges isn't available, like "fine-shifting" or "fine-nudging"?

Yes, you can select an automation point and press Option + Up arrow / Down arrow to change its value in fine increments.